Assigning IP on Cisco Routers

 

 Here I am taking the Equipment 
    

      -  Cisco 2811

      -  Serial DCE

      -  WIC-2T

 Assigning IP addressing : 

     Must keep in mind that every communication is based on IP, without IP you cannot do anything

           Configuration :

                  Router> enable

                 Switch to enable Mode

               

                 Route#

                 Now we are switch mode, For configuring Our router we should

                 move to configuration mode

                 Router#config t

                 After that you'll move to  config mode

                 Router(config)#

                 Now move to that serial on which wire is connected

                 In my example it 0/3/0

                 Router(config)# int s 0/3/0

                 Now we are at interface serial 0/3/0

                 Here we have to assign the ip address 

                Router (config-if)#ip address 1.1.1.3 255.0.0.0

                In this command after right next to ip address the ip address

                you want to assign and then after that the subnet of that class 

                is written

                Router (config-if)# end

That's It Ip is assigned, Same work is to be done on the other router For communication